VAPORSTAKE.com  N1471
          Home       Advantages      Spray-on Installation       Polyolefin Installation      Availability    
          Details     Screed Stake     WOC 2010 Contacts    ASTM Testing     MSDS     Sizes    Contact

Text Box:  VaporStake™ Installation with a polyolefin retarder  

Text Box: 1. Dip the pointed end of the VaporStake™ into the Stego® Mastic.  If necessary, use a utility knife to puncture a slit in the vapor retarder.  The slit should be no larger than the diameter of the VaporStake™ being used.

Text Box: 2.  Properly align the nail holes and drive the VaporStake™ through the StegoWrap®.  The VaporStake™ can be turned while the mastic is wet, but do not turn it after the mastic has set up.

Text Box: 3.  This is what the VaporStake™ looks like when viewed under the vapor retarder.  Notice the tight, continuous, non-corrosive seal that has been created around the VaporStake™.

 

 

 

 

 

    

 

 

 

 

Text Box: 5. Permanently leave the lower portion of the VaporStake™ attached to the vapor retarder. Text Box: 6. Finish slab over the VaporStake™

 

Text Box: 4. Using a power saw with a standard wood blade, cut the VaporStake™ above the seal but below the finished surface.  

 

Other Helpful Links

   ○1 Page PDF Flyer     ○Availability    ○Contact      ○Details      ○Downloadable PDF Binder