VAPORSTAKE.com  N1063 
          Home       Advantages      Spray-on Installation       Polyolefin Installation      Availability    
          Details     Screed Stake     WOC 2011 Contacts    ASTM Testing     MSDS     Sizes    Contact

Text Box: VaporStake™ Installation ● Use the VaporStake™ as you would a typical    stake ● Can be used with spray-on or polyolefin retarders ● Seal the vapor retarder to the VaporStake™ as    you would a pipe penetration   ● Using a power saw, cut the stake off above the    seal, but below the concrete’s finished surface ● The lower portion of the VaporStake™ remains in    place, permanently plugging the penetration ● No special tools, nails, glue, or caps required ● Cuts much faster, easier and safer than steel dowel   Text Box: VaporStake™ Description ● Non-corrosive, leak-resistant, plastic stake ● 24”, 30”, 36” and 48” lengths ● ±¾” and ±1-¼” diameters ● Made of solid PVC ● Acts as a permanent plug in the vapor retarder ● Helps meet ASTME E 1643-93 (re-approved 2005) ● Pre-pointed & pre-drilled holes for 16D duplex    nails ● Can be easily drilled in field for additional holes ● Made in the USA ● A Patent Pending Product   ● Seal the vapor retarder to the VaporStake™ as you     would a pipe penetration   ● Using a power saw, cut the stake off above the     seal, but below the concrete’s finished surface ● The lower portion of the VaporStake™ remains in     place, permanently plugging the penetration ● No special tools, nails, glue, or caps required ● Cuts much faster, easier and safer than steel dowels   VaporStake™ Availability ● Sold by the pallet ● 1,000 ea. per pallet ● 25 stakes per bundle for easy carrying ● To place an order email: info@vaporstake.com     or call: (714) 519-4211  

Text Box: 1. Using a sledge hammer, drive VaporStake™ into ground

Text Box: 4. Cut VaporStake™ above the seal but below the finished surface

Text Box: 3. Using duplex nails, nail forms directly to VaporStake™

Text Box: 5. Permanently leave lower portion of VaporStake™

Text Box: 6. Finish slab over VaporStake™

Text Box: 2. Seal barrier directly to VaporStake™

Text Box: 1.  If necessary, use a utility knife to puncture a slit in the vapor retarder.  The slit should be no larger than the diameter of the VaporStake™ being used. 

Text Box: 2. Dip the pointed end of the VaporStake™ into the Stego® Mastic.

 

Text Box: 3.  Properly align the nail holes and drive the VaporStake™ through the StegoWrap®.  The VaporStake™ can be turned while the mastic is wet, but do not turn it after the mastic has set up.

Other Helpful Links

   ○1 Page PDF Flyer     ○Availability    ○Contact      ○Details      ○Downloadable PDF Binder